Home‎ > ‎Palo Alto‎ > ‎

Factory Reset


From the console (RS-232), at boot, you should see a pause as this is shown.  Enter maint to get into maintenance mode.  
Flash: 32 MiB
Starting PCI
PCIe: Port 0 link active, 1 lanes
Net:   octeth0 [PRIME], octeth1, octeth2, octeth3
ata0: lba 48 mode
         Model: WDC WD2503ABYZ-011FA0 Firm: 01.01S03 Ser#: WD-WMAYP0E0WXDT
            Type: Hard Disk
            Supports 48-bit addressing
            Capacity: 239429.0 MB = 233.8 GB (490350672 x 512)
USB0:   (port 0) scanning bus 0 for devices... 1 USB Device(s) found



        Autoboot to default partition in 5 seconds.
        Enter 'maint' to boot to maint partition.

Entry:

You will be greeted at the maintenance recovery window.  Pres enter to continue.  
                    Welcome to the Maintenance Recovery Tool





     Welcome to maintenance mode. For support please contact Palo Alto
     Networks.

                  866-898-9087 or support@paloaltonetworks.com


< Continue                                                                     >










               Q=Quit,  Up/Down=Navigate,  ENTER=Select,  ESC=Back

Select Factory Reset 
                    Welcome to the Maintenance Recovery Tool


< Maintenance Entry Reason                                                     >
< Get System Info                                                              >
< Factory Reset                                                                >
< Set FIPS Mode                                                                >
< Set CCEAL4 Mode                                                              >
< FSCK (Disk Check)                                                            >
< Log Files                                                                    >
< Bootloader Recovery                                                          >
< Disk Image                                                                   >
< Select Running Config                                                        >
< Content Rollback                                                             >
< Set IP Address                                                               >
< Diagnostics                                                                  >
< Debug Reboot                                                                 >
< Reboot                                                                       >





               Q=Quit,  Up/Down=Navigate,  ENTER=Select,  ESC=Back





References: 

Comments